This breakout board has a 10K resister and 22pf cap on it. I'm just going to by the DS3234 chip alone, but I'm wondering if in my schematic I need those two components? They look like they might be used with the square wave pin or something? All I will do it connect the chip to my Atmega's SPI inte…

RCT DS3234 components needed?

johnwasser March 20, 2012, 3:27am 7

Yes, it looks like it will run fine on 5V.

Topic		Replies	Views
Using the DS3234 chip, instead of the B.O.B. General Electronics	2	1397	May 6, 2021
DS3234 RTC Square wave output problem Programming	9	1506	May 5, 2021
RTC DS3231's SQW pin goes LOW when on Vbat and triggers an unsolicited interrupt Sensors	11	3687	May 6, 2021
DS3231 RTC : what can be done with the SQW and 32Khz pins? Networking, Protocols, and Devices	7	31251	May 6, 2021
DS3234 batter back up not working Sensors	5	1975	May 6, 2021