DaveK YOU THE MAN!!! after reading what you said i went back and tryed your program with the new pots and really took the time to read the read out. O and now with the new pots the program is working like a CHAMP!!!! some of the pots thow on the read out on the val will not go all the way to 0 one will go no less then 18 I think ones at 5 and the other to are at 0. dose this mean the ones that will not go to 0 are bad? I only ask because there is a very little shaking still on cam number 2. but its not very bad at all.
mem
BTW, how long are the wires connecting your arduino board to each of the servos? and to the pots?
The wires from the pots are about 6" from the arduino. the outputs going to the servos and 5 volts and ground ......... 2 are 20' and the other 2 are about 30', yes feet! I em only able to add stuff to the arduino side like the decoupling capacitors. I found this wire that has 8 wires inside (i think its some kind of phone line stuff) and was able to Power my cams 12 volts power my servos 5 volts send the servo signals AND stll have 2 left over for the video. it worked out very well.
I'm gong to upload some vidos i made of this project so you all can take a look. ill post links in about 15 mins ;D