Receiving data from an off-the-shelf ZigBee sensor

Projects Networking, Protocols, and Devices
1

I've successfully managed to get two XBee modules communicating. However, I have a few off-the-shelf ZigBee sensors that I would like to connect as well. One of them, for example, is the Aqara temperature and humidity sensor. I'd like my Arduino to receive the data from this sensor via ZigBee.

When I connected the two Xbee modules, I used the firmware flasher to set the device addresses and network ID. If at all possible, is there a similar process if I were to use to use the Aqara sensor? I can't find any technical information about these off-the-shelf sensors to help me either.

2

The Arduino/xbee device you assign as the coordinator needs to implement the "zigbee 3" protocol.
Perhaps look at how Aqara devices are supported in the zigbee2mqtt project GitHub - Koenkk/zigbee2mqtt: Zigbee 🐝 to MQTT bridge 🌉, get rid of your proprietary Zigbee bridges 🔨

3

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.