# Recommendations for a Library Working with Live Audio

**URL:** <https://forum.arduino.cc/t/recommendations-for-a-library-working-with-live-audio/1322590>\
**Category:** Science and Measurement\
**Created:** [November 16, 2024, 1:36pm UTC](https://forum.arduino.cc/t/recommendations-for-a-library-working-with-live-audio/1322590 "2024-11-16T13:36:59Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![apex\_seals](https://dub1.discourse-cdn.com/arduino/user_avatar/forum.arduino.cc/apex_seals/32/1099701_2.png) [@apex\_seals](https://forum.arduino.cc/u/apex_seals)\
**Post date:** [November 16, 2024, 1:36pm UTC](https://forum.arduino.cc/t/recommendations-for-a-library-working-with-live-audio/1322590/1 "2024-11-16T13:36:59Z")

</div>

Good morning all,

I'm a first time poster here, but a long-time Arduino user. I'm an RF engineer with a master's degree that is a few years out of school, but I have been using Arduinos since I was in high school.

I have never used one to interact with live audio before. I have an incoming audio signal that carries digital data that I would like to decode. This is the time signal from radio station WWV. You can find more information about WWV here: [WWV and WWVH Digital Time Code and Broadcast Format](https://www.nist.gov/pml/time-and-frequency-division/time-distribution/radio-station-wwv/wwv-and-wwvh-digital-time-code)

Anyhow, a short summary of this signal is that it sends the current time with a clock signal at 1kHz and a data signal at 100Hz. I want to use an Arduino to identify these signals in real time and write the incoming binary from the data signal to a buffer for later decoding.

What library can I use to do this? WWV also supports several other signals for indexing, like a 1.5kHz tone at the top of the hour and a 1kHz long tone at the beginning of each minute.

I would love to write something like:

if \<1000hz short pulse\>:  
index seconds counter by 1;  
measure 100Hz subcarrier pulse length  
if \<100Hz subcarrier length is greater than 10ms\>:  
Bit is a digital "1"  
else if  
Bit is a digital "0"  
Write 100Hz subcarrier bit to buffer

etc, etc...

Thanks!

---

<div class="post-metadata">

**Author:** ![system](https://dub1.discourse-cdn.com/arduino/user_avatar/forum.arduino.cc/system/32/1140315_2.png) [@system](https://forum.arduino.cc/u/system)\
**Post date:** [May 15, 2025, 1:37pm UTC](https://forum.arduino.cc/t/recommendations-for-a-library-working-with-live-audio/1322590/2 "2025-05-15T13:37:15Z")

</div>

Closed on May 15, 2025, 1:37pm UTC

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.
