Reg-J1939

hi all, My project is based on CAN SAE J1939. In that i have some questions what is SPN and what is address claiming process. previously i have searched in internet but i cant able to get more informations.

Thanks in advance

Hi all, I am working in SAE J1939 standard based CAN project.In that standard i have some doubt as follows. What is SPN & what is address claiming.Thanks in advance.

DON'T CROSS POST!!!!!!!!!!!!!!!!!!!! http://forum.arduino.cc/index.php?topic=538386 I HAVE REPORTED THIS THREAD TO THE MODERATORS

Threads merged.

You should find here relevant information about address claiming in CAN SAE J1939: http://copperhilltech.com/blog/sae-j1939-address-claim-procedure-sae-j193981-network-management/

And here for Suspect Parmeter Numbers : http://felixequipment.com/Documents/Suspect-Parameter-Numbers-SPN-Codes.pdf

Thanks for your link. I was read that document fully.In that document they have mentioned that SPN is the diagnostic fault code terminology.what i got understand is that when any error occur in particular segment then the ECU will send corresponding SPN ID. whether my understanding is correct or not.Awaiting for your reply.Thanks in advance

Watch this video from 8:18 for SPN meanings:

https://www.youtube.com/watch?v=LxtLiP9P6G0

I saw the above link's video but still i have a doubt that whether SPN is used for diagnostic purpose.Thanks in advance