Remote AT Command between Arduino Nano v3.0 and Xbee S2Cs

Using Arduino Project Guidance
1

Hello everyone. Nice to meet you.

I'm not good at English, so please forgive me for using a translator.

First of all, I am Kang, a college student in Korea.

During the project using xbee and arduino nano v3.0, there was a difficult part, so I looked up a lot of articles and saw a lot of your repetitive articles, so I thought I was an expert.

What I'm curious about is this.

  1. There is a problem with communication between arduino nano + xbee S2C <-> xbee S2C.

When only XCTU was used, two xbee S2Cs were able to communicate.

However, when using Remote AT Command in API1 or API2 through arduino, the two xbee S2C's rssi pin's LED does not blink, so it seems that the packet is not transmitted or sent properly.

  1. I wonder if there is any other solution.

  2. If the parameters I touched are only ID, DL, JV, and AP, could it be resolved if I deal with other parameters?

2

This topic was automatically closed 120 days after the last reply. New replies are no longer allowed.