Reporgramming sparkfun openlog

jumpjack · April 4, 2012, 12:36pm

Found original OpenLog source:

magnuskarlsson/SDLogger/blob/27f5458e9e3796532fcbbf82ade138c84d72ca4a/OpenLog_v2/OpenLog_v2.pde

/*
 12-3-09
 Copyright SparkFun Electronics© 2010
 Nathan Seidle
 spark at sparkfun.com
 
 OpenLog is a simple serial logger based on the ATmega328 running at 16MHz. The ATmega328
 should be able to talk to high capacity (larger than 2GB) SD cards. The whole purpose of this
 logger was to create a logger that just powered up and worked. OpenLog ships with standard 
 57600bps serial bootloader running at 16MHz so you can load new firmware with a simple serial
 connection. This makes it compatible with Arduino if needed.
 	
 OpenLog runs at 9600bps by default. This is configurable to 2400, 9600, 57600, and 115200bps. We recommend 
 you attach a serial connection to reconfigure the unit to work at a different serial speed, but you 
 should be able to do it in software.
 
 Type '?' to get a list of supported commands.
 	
 During power up, you will see '12>'. '1' indicates the serial connection is established. '2' indicates
 the SD card has been successfully initialized. '>' indicates OpenLog is ready to receive commands.

This file has been truncated. show original

/*
12-3-09
Copyright SparkFun Electronics© 2010

Can opensource be copirighted?!?

Topic		Replies	Views
openLog and Arduino General Guidance	13	10252	May 5, 2021
help, entering data to SpkFun OpenLog, via Arduino Frequently-Asked Questions	10	5989	May 6, 2021
9 DOF sensor stick + Open Log trouble General Guidance	27	9019	May 5, 2021
Openlog non funziona? Generale	4	1671	May 7, 2021
OpenLog - Speicherfehler ? Deutsch	13	3506	May 6, 2021

Reporgramming sparkfun openlog

Related topics