RS485

Hi all,

I implemented a communication between two arduinos using RS485. Everything went fine until I connected the Liquid Crystal Display that comes with Starter Kit.

As soon as I connected the LCD, the slave start to have a erroneous behavior not being able to decode the messages sent by the master.

The messages are very simple: "S,E,1,100;"... when I start the serial monitor the first 3 messages are ok, but after that the Serial.read reads a lot of trash.

An important note, Master Arduino is always sending data to Slave without stoping.

Any ideias why this is happening? Is the LCD impacting Serial TX interrupts?

Thanks

Welcome to the forum.
Please read this post on how best to write a meaningful post, in particular, items 11 and 15.

How to use this Forum - Please Read


Paul