Hello everyone in the forum, this is my first post (I just registered).
I recently purchased an Arduino duemilanove atmega 328 and immediately infected with it, Arduino is a miracle.Can be connected to things that are lying in drawers and I was always interested in how it works, but otherwise I am by nature a bit lazy I made ??pcb , soldering iron and studied how they work microcontrollers (maybe if I had more free time)
So far I have successfully connected the LEDs, 7 segment LED, 2x16 LCD, nokia 3310 LCD, Siemens M55 LCD Dallas1820 sensor and mass of things.
Now I've encountered a problem on how to connect and start to work VFD display on the Samsung 96L08AA2 Rev.A to Arduino duemilanove Atmega328.Display works with the circuit in figure attached,ATMEGA8 with only two wires DIN and CLK (although there is a pin RST but not conected.
I found datashet of display and 96L08AA3 (I guess it's the same display) so if anyone knows it would be very grateful.
What is this kind of communication that uses 2 lines (data and clock) I2C or SPI (confuses me the rRST that is not connected.
96L08AA3.pdf (403 KB)
