Seeeduino at 3.3V + SDCard - No Module

Other Hardware Storage
1

I've been trying to interface my Seeduino v 2.2 with a SDCard Directly, once it has a 3.3V Switch. I've soldered wires to a microSD adapter to connect it to the arduino. All I've been getting is this:

card.init failed
SD errorCode: 0X1
SD errorData: 0X0

I'm using short wires, and already tried running it with pull up resistors, but the output just won't change. Any guesses?

2

No pull-ups are required. Chip select is the only line where a pull-up makes sense because this disables the SD when when the SPI bus is shared with other devices.

SD adapters sometimes don't take the heat of soldering. I just use a bare SD socket with 3.3V systems and no other parts.