I created a schematic for the MAX3485 with the ESP32, but I have a question about the selection of biasing resistor(R39,R40) values. Some people use 4.7k, 10k, and 20k ohm resistors, but I'm unsure what the exact value should be and how much current is required. Does anyone have insights or suggesti…

Selecting biasing resistor values for MAX3485

jim-p August 19, 2025, 2:31pm 12

No.
So have you decided on biasing resistors?

Topic		Replies	Views
RS485 bus termination and failsafe bias General Electronics	11	7702	May 6, 2021
RS485 E Arduino Software	9	1898	May 7, 2021
rs485 - is shared ground required? General Electronics	31	57480	May 6, 2021
Rs485 Hardware Deutsch	6	1737	May 6, 2021
De vueltas con el bus rs485 Español	7	7147	May 6, 2021