Hello!!
i have 2 xbee radios "pro s2b" and 2 xbee shields and configure them to connect one as coordinator and the another one as End point and they work correctly.
Then i try to use the coordinator without shield and the End point device with shield.
the xbee radios use 3.3v with it's pins so i use logical level converter "https://www.sparkfun.com/products/12009"
to convert 5v pins to 3.3v
and i connect the pins in the coordinator device to the arduino uno as the following:
Vcc ==> 3.3v
GND ==> 0v
DOUT ==> pin 0 RX in uno through the converter.
DIN ==> pin1 TX in uno through the converter.
So the problem here is
When i powered up the coordinator device the association LED in the End point device shield blink rapidly.
that's mean it's join the network with the coordinator but not receiving data.
so i can't send data through the coordinator, there is something wrong
can any one Guide me please?
Thanks 