Hi, I'm new to the forum and need your help.
I'm working with a LB1847 which I control with a PIC16F873 but have not had success since the problem is that I can not embed the code in the correct sequence of the PIC should I apply to the driver.
I can not interpret the information in the table datashets sequence of LB1847 and I think that's my mistake, I hope I can help with that part because the logic is ready but only lack the sequence that should receive the drive for the engine forward.
Sorry for my English. ;D
Greetings
Hi moyin,
This forum is all about the Arduino board. The Arduino does not use a PIC processor but uses the ATmega family of processes from Atmel. These use a C / C++ compiler in a dedicated environment.
Therefore while the odd member might know about PICs the help available here is not for PICs. Sorry. :-[
Sorry, thanks for pointing out the situation.
greetings
