Hello all, I'm running out of functionality on a project that's using an RBBB from Modern Device. I'd like to add an LCD, but don't think I have the program memory or pins available to just slap an LCD on the RBBB. So, I started looking at LCD drivers that can communicate via I2C, SPI, or some oth…

Serial LCD driver, vs. I2C slave arduino?

system September 22, 2009, 12:12am 11

ill_switch,

Sorry, I wasn't paying attention. If you're already using I2C, you're absolutely right about just adding another slave being the easiest way.

Regards,

-Mike

Topic		Replies	Views
Master Slave Project General Guidance	27	15900	May 5, 2021
I2CLCDextraIO available - 2 pin LCD controller board Displays	18	8328	May 6, 2021
Using a arduino to reduce the number of pins needed for a LCD Libraries	25	13278	May 6, 2021
Seriously Cheap Serial LCD Exhibition	13	16380	May 6, 2021
help understanding I2c and arduino Syntax & Programs	22	9955	May 6, 2021