Hello all,
I tried to connect the arduino M0 with my PC and it says :
"Couldn't find a Board on the selected port. Check that you have the correct port selected.
If it is correct, try pressing the board's reset button after initiating the upload. "
So I tried to check the port option but it is grayed out. In device manager the port is not shown.
Then as per the discussion above I tried to install the driver from "CH341SER.ZIP". It shows that :
"The drive is successfully pre-installed in advance!"..
Now,again when I am trying to connect arduino it is not detecting the board.
Is it that my board is faulty?? Should I have to check anything else??
Please help to solve this problem.
Any help is greatly appreciated.
Thanks in advance