Hello, I’ve hooked up a sim800 gsm modem on an UNO (pin 0, 1). I wrote a simple sketch which sends 2 modem commands over the serial connection. First setup a call, delay 5 seconds and then disconnect the call. When I upload the sketch from the arduino ide everything works fine (tx is lid, modem rec…

Serial (UART) communication

Topic		Replies	Views
SIM800l + Arduino UNO does not respond Networking, Protocols, and Devices	12	7918	May 6, 2021
USART does not transmit any longer after power off IDE 1.x	5	2095	May 5, 2021
Sending AT commands through serial monitor (Arduino Uno) Programming	3	1980	May 5, 2021
Uno to A6 GSM interfacing on UART Programming	2	408	May 5, 2021
Ayuda urgente Español	3	1207	May 6, 2021