Servo Problem stuck at 180

Other Hardware Motors, Mechanics, Power and CNC
1

Hi everyone,
I am pretty new to arduino and this forum I am trying to elbow my way, I am doing good with code, but I am facing an issue with One servo, no matter what the value I put it will turn immediatly to 180 and stay stuck to this value. Does any of you run into this issue ? Is the servo dead ?

I tried to change its position, swap with another one; It does it only with a specific servo. Is there a way to fix it ?

2

Welcome. You must have missed something?

3
  • If the problem follows the servo, get a new servo.
4

A servo motor contains a DC motor, a circuit board and a potentiometer. One of those items might have created a short, bypassing the circuit board and sending DC directly to the motor.

5

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.