ServoMG995 is vibrating even when not in motion

Other Hardware Motors, Mechanics, Power and CNC
1

I am using servo MG995 with the help of arduino UNO connecting signal bus (orange wire) to pin9 of arduino and brown to ground and red to 5V arduino pin
After its motion is over,it is producing vibration(little sound).why ??
Can I stop it vibrating or it will continue???
Pls help.
Thanks.

2

It is not a good idea to power a servo from the Arduino 5v pin. Give the servo its own power supply with the servo GND connected to the Arduino GND.

If you want more help you need to post your program.

...R

3

And as well as that, if the servo is under any load it may still vibrate a little. It's trying to hold its position so if there is any load trying to move it then it still needs to keep the power on.

Steve

4

Thanks for your help