ok so you got the pdf
see where it says installation and it says installing the transmitter module
- make sure transmitter is turned off
- remove the current RF module from the transmitter
- carefully insert the DSM module (SM1000) notting the orientation of the connector pins
- rotate and angle the antenna on the module to vertical
- if the transmitter is PPM AND PCM compatible make sure the transmitter is programmed to PPM modulation mode
now lets say the receiver is already installed in the car and we can take a few steps forward to binding this is where my problem is
- make sure everything is turned off
- with the receiver turned off press and hold the bind button on the receiver
- turn on the receiver while holding the bind button
- release the bind button when the led flashes green
- with the transmitter turned off place the transmitter sticks and aux channels in their desired failsafe position
- press and hold the bind button on the transmitter module (SM1000)
- turn the transmitter on while holding the bind button
- release the bind button after the green led flashes
now this is how you would normally set these up if you have the transmitter that the module fits into in the instalation process but I dont have the transmitter this is where I want the arduino to come in and replace the transmitter
the modules have 5 holes in the back fot the transmitter pins to fit into to conect the module to the transmitter only 3 of the holes are actually used tho 1 for 6v+ 1 for - and 1 for PPM (its used for all communication from transmitter to module and back)
all I need to do is connect the arduino to the PPM hole in the module and program the arduino to send a neutral PPM modulation signal and connect 6v to the module and then I can complete the bind process