Hallo zusammen,
ich habe hier ein SkyTraq Venus 6 GPS ST22 Modul, welches ich erfolgreich mit den default Einstellungen betreiben kann.
Wenn ich nun von den 1 Hz und 9600 bps, auf 10 Hz und 38400 bps umstellen will, muss ich was machen? Ich stehe völlig auf der Leitung und verrenne mich in irgend welche Ecken.
pgs-st22.pdf:
Example:
To switch the baud rate to 38400 send the following hexadecimal bytes to the receiver:
A0 A1 00 04 05 00 03 01 07 0D 0A
Note: the above shown bytes are in hexadecimal format, do not send as text string.To switch to 10 Hz position update rate the following hex bytes are send to the receiver:
A0 A1 00 03 0E 0A 01 05 0D 0A
Verstehe ich es richtig, dass ich einfach so die Baudrate ändern muss? Wie soll man so etwas anstellen? Ich kann doch nicht einfach mit Serial.begin eine andere Baudrate einstellen und wie kann ich in hex Format bytes versenden?
Ich hoffe, dass mich jemand in die richtige Richtung schieben kann.
Grüße,
Roland