Some time ago there was a post on the forums here of, what I think, is was the smallest Arduino.
This guy soldered the few components (crystal, capacitor, etc...) that were needed to run Arduino directly to the processor or maybe he used a pin header. Not sure...
I have been looking for that thread last night but not been able to find it. Anyone remembers the thread I talk about and can link me to it?
Thank you in advance!
JD
Take a look at this:
http://www.geocities.jp/arduino_diecimila/obaka/project-2/index_en.html
Thank you very much!
I am not 100% sure if this was the one I had seen before, it seems close enough. I think the one I had seen here before didn't have the icsp header and also no reset switch.
If anyone has seen other versions, similar to this one, please post!
Five page thread here: http://www.arduino.cc/cgi-bin/yabb2/YaBB.pl?num=1239733868/0
Take a look at this:
http://www.geocities.jp/arduino_diecimila/obaka/project-2/index_en.html
It seems in that link the chip is running on a internal clock of 8 MHz so adding a Crystal or Ceramic Resonator 16MHz may be a good addition.
@westfw,
Not the one I was looking for. Thanks anyway!