I`m trying to make a k-wire interface without the elm chip.(it is not av. in my country) I used this schematic and info fromhttp://blog.perquin.com/blog/category/odbii/. So, to init the k-wire (fast way) I need to : Wait for 300ms with K line high. Pull K line low for 25 +/- 1 ms Let K line ris…

Software serial problem -> K-wire without ELM

callmecata February 9, 2016, 4:27pm 9

Any luck ? Did it work ?

Topic		Replies	Views
CAN OBD project. - One byte 5baud init and then 10400baud serial data on one line... General Guidance	7	3793	May 5, 2021
Arduino + L9637 K-Line reader - getting 10400 baud on SoftwareSerial Networking, Protocols, and Devices	4	7089	May 6, 2021
software serial2 Bugs & Suggestions	32	15913	May 6, 2021
k-line arduino project, speed and brake lights General Guidance	7	8172	May 5, 2021
Problems with software serial code Interfacing	8	3687	May 6, 2021