[SOLVED] Arduino killing all my temp sensors?

Projects General Guidance
5

Maramor:
I am still a newb so sorry if this is simple but I found if you are using serial monitor you need to make sure the speeds are the same.
If you set in code then change the serial monitor to match.

Also in 2nd picture, your capacitor is behind the feeds, wouldn't it need to be in front? Again I am just guessing as I don't really know :slight_smile:

Hope this helps.
I have RHT03, DS1307, BMP085, 16x2 LCD connecting to a UNO. But not fully working yet.
Sensors are nice though :wink: are yours good?

When I say incoherent readings I meant -30C then jumping to +450C, not ASCII gibberish like when the speeds are not the same.
AFAIK, resistors can be put anywhere as long as they are there. I was confused too because on schematics and tutorials you can find, they can be placed after or before a component but I googled it up and it seems it makes no difference.

My sensors are good and I can see a lot of applications for them, when they don't heat up like crazy!