I'm a relatively new programmer, working on an Adafruit Trinket board with Arduino IDE. I've written a program to read voltage (0-5V) from input pin 2, and cause a certain LED to blink depending on the voltage level. If the voltage is less than 1V, a red LED should blink; if it is greater than about…

SOLVED: n00b problem, can't get analogRead to work

Grumpy_Mike April 7, 2014, 8:56pm 7

Grumpy_Mike:
Further Edit
You are reading analogue 2 and wiring up to analogue 1

Topic		Replies	Views
analogRead problem Troubleshooting	4	1159	May 6, 2021
n00b Question: analogRead giving false positive Interfacing	13	4763	May 6, 2021
Arduino MEGA analog problem 3rd Party Boards	6	1696	May 6, 2021
Basic problem with analogRead() IDE 1.x	14	3785	May 5, 2021
analogIn only showing floating voltage Troubleshooting	4	1632	May 6, 2021