Hi everyone,
I ordered this module and simply cannot find a pinout for it... it is a 2x28-pin-interface. Either I am asking Google the wrong questions or I am the first to ever buy one of those g
If anybody could direct me to an information where the 3v3, Gnd, MISO, MOSI, SCK and CS pins are located that would be great.
Thanks in advance!
Blueish
I wonder if it is a clone of the ermicro board: Integrating Wiznet W5100, WIZ811MJ network module with Atmel AVR Microcontroller | ermicroblog
Hi there,
thanks for your reply. The Wiznet WZ830MJ board (2nd from the left in the first image in the mentioned blog) looks stunningly similar, however it does have a W5300 chip and a 16/8 bit bus interface (no SPI). I checked the Wiznet page and other datasheets from them but did not find a W5100 module with a similar "two 2.54mm pitch 2 x 14 header pin" interface. Both the amazon article page as well as several seller posts on ebay claim that the SainSmart module has SPI though...
I contacted SainSmart as well as the amazon seller for help on the datasheet but did not yet get any replies- I'll keep you posted.
Having a hard time believing that I am the first guy which actually tries to do something with this module...
Cheers Blueish
Hi, me again-
the Amazon seller replied with a link to a zip file with the unbelievable size of 425MB... after downloading I found the entire schematics for a STM32 board with TFT display and bells and whistles and whatnots....
After rooting through the files I found the following piece of wisdom inside a huge diagram which answered my question. Case closed.
Cheers Blueish
