SOME ONE CAN HELP ME I AM GETTING STARTING ON ARDUINO

Development Tools IDE 1.x
1

Hi when i try load this config into arduino give this message of error someone can help ?

O sketch usa 13314 bytes (41%) de espaço de armazenamento para programas. O máximo são 32256 bytes.
Variáveis globais usam 533 bytes (26%) de memória dinâmica, deixando 1515 bytes para variáveis locais. O máximo são 2048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x51
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x51
Problema ao carregar para a placa. Veja http://www.arduino.cc/en/Guide/Troubleshooting#upload para sugestões.

2

Shouting in CAPS is not a good start.

It seems that you might not have selected the correct board or MCU type ?

What board do you actually have and is it a clone or a REAL ARDUINO ?

What OS ?

Please read the posts at the top of the forum for what information you should be posting.

3

Hi sorry for incovenience, i am attach a image from CHIP and i dont know to find if was REAL ARDUINO, i am using Win 10 pro.

IMG_0676.jpg
IMG_0676.jpg895×500 156 KB

4

In the IDE you should select the NANO
Then you will probably need to select the FLAVOUR and there will be 3 choices.

Based on your picture the chances are it will be either the 328P or 328P (Old Bootloader) of which one of them should work and the other will probably fail.

Ensure you also have the correct COM port selected in the IDE as will be shown in windows DEVICE MANAGER under COM & LPT PORTS when you plug in the NANO.