I'm adapting the serial input version of a sketch to use analog input values 0-5vdc. I noted the code to explain what I'm doing. Everything works except when it displays analog read value I get the correct value, but moving to value (TravelA) is incorrect. Instead, I'm getting 14194 as TravelA value…

something missing when calculating Analog values?

system May 24, 2018, 9:30pm 4

What do the prints tell you is going-on?

Topic		Replies	Views
Reading Analog Voltage () General Guidance	19	5309	May 5, 2021
Analog read stopped while PWM out Programming	24	6314	May 5, 2021
Programming For Stepper Motor Programming	46	5149	May 5, 2021
Change direction on Stepper based on Analog Read Programming	15	4206	May 5, 2021
ok i dont know why this is not working pot pin with steps Programming	29	6851	May 5, 2021