If i put in this code my serial monitor reads the sensor correctly. 1024 when its clear, 0 when its blocked. int led = 13; void setup() { pinMode(led, OUTPUT); Serial.begin(9600); } void loop() { int triggerValue = analogRead(A2); Serial.println(triggerValue); delay(1); …

Something simply I'm sure

Grumpy_Mike May 13, 2014, 3:26pm 2

What am I missing here?

The use of two equals signs in an if statement perhaps.

Topic		Replies	Views
if command question Programming	17	3434	May 5, 2021
Newbie :) 'if' help Syntax & Programs	13	4909	May 6, 2021
Arduino and LEDS Programming	5	1385	May 5, 2021
Problem with "if" statement and pins..... Programming	4	742	May 5, 2021
Suggest: Warn on = vs == in "if" statement Uno Punto Zero	12	8784	May 6, 2021