SRF10 Mounting Kit Specs

Forum 2005-2010 (read only) General Frequently-Asked Questions
2

Mounting the SRF10
You may have notice that there are no mounting holes on the SRF10 module! That was deliberate to keep the module as small as possible. So how do you mount it? Here are three suggestions:

  1. A straight or right angle 0.1 inch connector soldered to your PCB.
  2. Using two 9.5mm rubber grommets. Two holes should be drilled into the panel you're mounting the SRF10 to. The hole centers should be 0.7inches (17.78mm) apart and the holes drilled 0.5 inches (12.7mm) in diameter. The two grommets should then be fitted to the panel and the SRF10 gently pushed into them.
  3. Using our SRF10 Mounting Kit, shown below.