I'm building my first standalone arduino project (atmega328 on stripboard). I power it through a 7805 regulator which has 10uF caps on input and output. The 7805 is on a separate circuit board. The wire from the 7805 to atmega328's VCC is about 20 cm (ten inches) long, quite thick (0.75mm2) wire, pl…

Standalone arduino/capacitors

system December 9, 2012, 9:25pm 3

OK, thanks Mike. Does it have to be elco or will ceramic do?

Topic		Replies	Views
Suggested capacitor value between VCC and GND for standalone Atmega328? General Electronics	7	9284	May 6, 2021
Decoupling a Standalone Atmega328 and other components 3rd Party Boards	10	2297	May 6, 2021
Do I need a CAP on VIN to ground General Guidance	7	2185	May 5, 2021
Caps on and around ICs 3rd Party Boards	6	1590	May 6, 2021
Decoupling capacitors on a bare-bones Arduino 3rd Party Boards	7	1417	May 6, 2021