I'm building my first standalone arduino project (atmega328 on stripboard). I power it through a 7805 regulator which has 10uF caps on input and output. The 7805 is on a separate circuit board. The wire from the 7805 to atmega328's VCC is about 20 cm (ten inches) long, quite thick (0.75mm2) wire, pl…

Standalone arduino/capacitors

system December 11, 2012, 11:12pm 8

Thank you all for thorough explanations. I'll use 0.1 uF ceramics then.

Topic		Replies	Views
Suggested capacitor value between VCC and GND for standalone Atmega328? General Electronics	7	9284	May 6, 2021
Decoupling a Standalone Atmega328 and other components 3rd Party Boards	10	2297	May 6, 2021
Do I need a CAP on VIN to ground General Guidance	7	2185	May 5, 2021
Caps on and around ICs 3rd Party Boards	6	1590	May 6, 2021
Decoupling capacitors on a bare-bones Arduino 3rd Party Boards	7	1417	May 6, 2021