Hey, I fried one of my cables to a stepper motor(1 A), it happens in the soldering point between two normal jumper-cables, is there a way to test the quality of the solder, so this does not happen again ? Thank you

Stepper motor cable fried, how to check quality of solder

Grumpy_Mike October 26, 2017, 9:02am 2

Measure the resistance of the joint with a DVM.

Topic		Replies	Views
Is this solder ruined? General Electronics	15	5313	May 6, 2021
Solder joints, possible cause for concern? General Electronics	7	846	May 6, 2021
Difficulty soldering stepper motors... General Electronics	8	990	May 6, 2021
Can soldering heat damage ceramic capacitors? General Electronics	10	14266	May 6, 2021
How Do I Solder DC Motors With Flimsy Copper Pieces To Wires? General Electronics	19	12593	May 6, 2021