Stepper motor problem [ELEGOO]

Other Hardware Motors, Mechanics, Power and CNC
1

Hey, I bought an Elegoo UNO R3 Project starterkit from amazon to start crafting my project for school. I want to make a "tea-bag crane". Basically, I want a button to set the 1-digit 7 segment display up +1 minute every time I press, and then, run down from those minutes until point 0. At that point, my stepper motor is supposed to pull the tea-bag out of the cup. Done.

However, I can't even get my motor to work. Maybe it's because I don't have an original Arduino? I watched a short tutorial, in the video it works perfectly. I don't know if I have to start the motor somehow to have it work, but I'm pretty sure I've done exactly the same as in the video.

In conclusion: Stepper Motor doesn't work, only LED - D lights up on the Stepper Motor driver module. Here's the tutorial I watched: 28BYJ-48 stepper motor and ULN2003 Arduino (Quick tutorial for beginners) - YouTube

Any help appreciated!

(Port chosen, board chosen, ... I've worked with these things in school sometime)

2

You need to tell us what stepper motor you have and if it is not a 28BYJ-48 you need to post a link to the motor datasheet.

And you also need to post the program and tell us in as much detail as possible what happens when you run it.

...R

3

Could you also take a few moments to Learn How To Use The Forum.
Other general help and troubleshooting advice can be found here.
It will help you get the best out of the forum in the future.

Then you will have a much better idea of what we need to see.
Such as the DRIVER you are using etc.