Hello everyone, I'm designing a system that uses stepper motor to drive a certain carriage. The problem is that the stepper cannot get past 150rpm. Here is my current setup: Arduino Uno Rugged motor shield (30-40V max, 2.8A max) Stepper motor 4-wire (6A/Phase; 3V; 0.5 ohm) Power input in the sh…

Stepper motors can not get past 150rpm

Other Hardware Motors, Mechanics, Power and CNC

system October 23, 2012, 1:03am 4

Disconnect the motor from the carriage and see if the motor runs faster. If so, something in the carriage is preventing the motor from running faster.

Topic		Replies	Views
Stepper motor high RPM? Motors, Mechanics, Power and CNC	5	5774	May 6, 2021
Assistance with Stepper motor situation General Guidance	8	1663	May 5, 2021
Problem with setting RPM! Motors, Mechanics, Power and CNC	7	1344	May 6, 2021
Arduino + Step MOTOR + DRIVER = max rpm and torque Motors, Mechanics, Power and CNC	6	7848	May 6, 2021
Stepper Driver Problem! Motors, Mechanics, Power and CNC	8	1599	May 6, 2021

Stepper motors can not get past 150rpm

Related topics