Hi the routine attached is to drive a stepper motor approx 1/2 turn forward and back again just once when pin3 goes HIGH. When using "setSpeed (1000) the motor runs fine (no trigger yet it just bounces) and the serial output correctly shows pin3 status and motor speed.....when I change it to "setSp…

Stepper "setSpeed" problem

UKHeliBob October 9, 2017, 4:25pm 2

#define STEPS_PER_OUTPUT_REVOLUTION 32 * 32  //2048

2048 ?
I read no further I am afraid

Topic		Replies	Views
Problem using "setSpeed" for stepper control Programming	5	1192	May 5, 2021
speed up stepper motor Programming	1	851	May 5, 2021
Stepper Object and setSpeed() function. General Guidance	1	1509	May 5, 2021
<stepper.h> gives 1/4 steps Programming	7	3272	May 5, 2021
Stepper motors settings Programming	8	3076	May 5, 2021