I posted this last week and changed my inputs to be INPUT_PULLUP and set the software to look for a LOW signal. Which works great when I just a little jumper from ground to pins 2-7 my corisponding outputs go low triggering pins 8-13 so when 2 is low pin 8 goes low and fires a relay, 3 goes low and …

Still having trouble with digital reads

ChrisDev September 24, 2017, 3:14am 3

Ok I edited it.

Topic		Replies	Views
my "output pin" is in "high" when not triggered and "low" when triggered Programming	14	2771	May 5, 2021
Setting the pins that switch a 4-channel relais creates low on other pin General Electronics	5	1015	May 6, 2021
Digital Pins not outputting enough voltage [solved] Programming	13	6294	May 5, 2021
Newbie Question Programming	18	1665	May 5, 2021
What could I be doing wrong? General Guidance	26	3934	May 5, 2021