Hi everybody, I am working on a project, which objective is to find the force applied to a point at a carbon fiber wing bar. I am using two strain gauges BF-350, 2 resistances (330ohms), arduino and a HX711. But the problem is because is just reading zero´s. I don´t know if the problem is the str…

Strain gauge (BF-350) + hx711 (always zero)

tiagodornellas30 November 23, 2021, 6:19pm 5

Do you mean this?

Topic		Replies	Views
Strain Gauge with HX711 Load Cell Amp Sensors	8	1240	May 18, 2021
Strain gauge issue! Not reading properly. Sensors	2	1560	May 6, 2021
strain gauges, wheatstone bridge, HX711 to measure strain values General Guidance	20	11800	May 5, 2021
3-wire strain gauge - HX711 Issue General Electronics	11	7749	May 6, 2021
BF350 Strain Gauge with HX711 Issues only shows 8388607 General Guidance	32	272	November 11, 2025