So I purchased a 2kg scale with the intention to link it to an arduino to send the scale readings to the serial port for further use. I obtained a INA125P In-amp with the hopes to amplify the signal to do this. There are several examples out there of folks hacking scales in this manner. I am running…

Strain Gauge to INA125 Troubles

Topic		Replies	Views
Gain problem using INA125 chip for strain gauge General Guidance	15	8804	May 5, 2021
INA125P on load cell Science and Measurement	5	4032	May 6, 2021
To amplify mV to Volts with INA125 General Electronics	21	7370	May 6, 2021
Load cell with INA125, issues with resolution vs. range set by gain Sensors	3	2458	May 6, 2021
Reading Strain Guages / Scales Sensors	4	5151	May 6, 2021