Hi Group Im trying to hoook 2 straingauges up to INA125 Instrument Amps. Got the parts ordered, but Im having difficulties with the schematics. I will need both Positive and negative strain from my 120 ohm straingauges. The straingauges will vary from 119.8 Ohm to 120.2 ohm so I need a Whetstone…

Straingauge and INA125

MarkT April 2, 2014, 10:29pm 2

Have you looked at the examples in the datasheet for the INA125?

There are several resources out there if you search,
http://cerulean.dk/words/?page_id=42

Topic		Replies	Views
To amplify mV to Volts with INA125 General Electronics	21	7393	May 6, 2021
Gain problem using INA125 chip for strain gauge General Guidance	15	8808	May 5, 2021
Strain Gauge to INA125 Troubles Sensors	8	13948	May 6, 2021
Digital Bathroom Scale to Arduino. Is this setup right? General Guidance	4	4696	May 5, 2021
INA125P on load cell Science and Measurement	5	4039	May 6, 2021