Hi All, I've come across a strange behaviour when I set pinMode by an array. The setup: Arduino Nano 10x LEDs wired individually (from ground, through resistors) to pins 2 to 11. The wiper of a 10k pot wired to A7 (i.e. 0-5v input). The code progressively lights up the LEDs as the pot is turned …

[image] serious_sam: pinMode(A7, INPUT); This is your problem. Remove this line. DO NOT USE pinMode() ON PINS USED ONLY FOR analogRead(). Pins A6 and A7 are outside the range of digital pins so using pinMode() on them indexes off the end of two tables in the firmware. Pin A7 is accident…

Strange behaviour setting pinMode by array

Projects Programming

serious_sam August 25, 2021, 10:30am 18

Just tried it with that line removed. Worked perfect. That was it. Thank you !

Topic		Replies	Views
array Programming	6	1730	May 5, 2021
Location of pinMode matters? Programming	7	4626	May 5, 2021
Need a little guidance... Strange behavior. Programming	15	4223	May 5, 2021
6 Leds with fade and lots of fun Programming	6	2369	May 5, 2021
Handling large numbers of input pins using arrays. Programming	7	1047	May 5, 2021

Strange behaviour setting pinMode by array

Related topics