Hi I'm new to electronics, new to this forum. I'm sure this has been asked a million times before - is it standard procedure to submit a Fritzing sketch to this forum before trying it out on my Arduino and risk blowing some parts?
is it standard procedure to submit a Fritzing sketch to this forum before trying it out on my Arduino and risk blowing some parts?
No in general we look down very badly at Frtizing, if you want to see if you have made any errors we would encourage you to submit a proper schematic. These can be read by others where as a Fritzing abortion is simply a physical layout diagram which is very little use once the circuit gets anything past the utterly trivial.
Ah, okey doke. Thanks
Hi,
Grumpy_Mike, well put.
Can I copy and paste that into my notepad file of over frequent replies on Arduino Forum?
Tom..... 
PS too late I already have.
bobmaxine:
Hi I'm new to electronics, new to this forum. I'm sure this has been asked a million times before
The search bar at the upper right of the web page could tie into that nicely.
TomGeorge:
Hi,
Grumpy_Mike, well put.Can I copy and paste that into my notepad file of over frequent replies on Arduino Forum?
Tom.....
PS too late I already have.
Good job I have no objections then