This is part of a bigger project I'm working on - I thought it would be better to break it down into bits which I can then later join up
I've just started working with Arduino and for this question I'm trying to switch a LED on when I scan a RFID and switch the LED off when I scan the same RFID the second time
This is my code for reading the RFID and switching on the LED - it's basically one of the examples but simplified
/*
* Initial Author: ryand1011 (https://github.com/ryand1011)
*
* Reads data written by a program such as "rfid_write_personal_data.ino"
*
* See: https://github.com/miguelbalboa/rfid/tree/master/examples/rfid_write_personal_data
*
* Uses MIFARE RFID card using RFID-RC522 reader
* Uses MFRC522 - Library
* -----------------------------------------------------------------------------------------
* MFRC522 Arduino Arduino Arduino Arduino Arduino
* Reader/PCD Uno/101 Mega Nano v3 Leonardo/Micro Pro Micro
* Signal Pin Pin Pin Pin Pin Pin
* -----------------------------------------------------------------------------------------
* RST/Reset RST 9 5 D9 RESET/ICSP-5 RST
* SPI SS SDA(SS) 10 53 D10 10 10
* SPI MOSI MOSI 11 / ICSP-4 51 D11 ICSP-4 16
* SPI MISO MISO 12 / ICSP-1 50 D12 ICSP-1 14
* SPI SCK SCK 13 / ICSP-3 52 D13 ICSP-3 15
*/
#include <SPI.h>
#include <MFRC522.h>
constexpr uint8_t RST_PIN = 5; // Configurable, see typical pin layout above
constexpr uint8_t SS_PIN = 53; // Configurable, see typical pin layout above
int led = 47;
MFRC522 mfrc522(SS_PIN, RST_PIN); // Create MFRC522 instance
//*****************************************************************************************//
void setup() {
Serial.begin(9600); // Initialize serial communications with the PC
SPI.begin(); // Init SPI bus
mfrc522.PCD_Init(); // Init MFRC522 card
Serial.println(F("Read personal data on a MIFARE PICC:")); //shows in serial that it is ready to read
pinMode(led, OUTPUT);
}
//*****************************************************************************************//
void loop() {
// Prepare key - all keys are set to FFFFFFFFFFFFh at chip delivery from the factory.
MFRC522::MIFARE_Key key;
for (byte i = 0; i < 6; i++) key.keyByte[i] = 0xFF;
//some variables we need
byte block;
byte len;
MFRC522::StatusCode status;
//-------------------------------------------
// Look for new cards
if ( ! mfrc522.PICC_IsNewCardPresent()) {
return;
}
// Select one of the cards
if ( ! mfrc522.PICC_ReadCardSerial()) {
return;
}
Serial.println(F("**Card Detected:**"));
//-------------------------------------------
byte readCard[7];
for (int i = 0; i < mfrc522.uid.size; i++) { //
readCard[i] = mfrc522.uid.uidByte[i];
Serial.print(readCard[i], HEX);
}
if (readCard[0]!=0)
{digitalWrite(led, HIGH);
}
Serial.println(F("\n**End Reading**\n"));
delay(1000); //change value if you want to read cards faster
mfrc522.PICC_HaltA();
mfrc522.PCD_StopCrypto1();
}
//*****************************************************************************************//
How can I code it to switch it off when the same RFID has been scanned the second time?
Thank you