TDC7200 interface with Arduino nano

I'm currently involved in LASER Range Finder for long range. So, I'm planning to go ahead with TDC7200 for time of flight measurement but stuck with the programming part. Can anyone help me with code or guide through this ?? :confused:

Can anyone help me with code or guide through this ??

Without a link to the hardware? No.

Why did you chose that piece of hardware, if you did not know how to use it?

The TI data sheet is horrible :frowning:

The chip needs a precise clock signal (recommended 16MHz), start and stop signals, and SPI is used for communication with a controller (Arduino). Level conversion will be needed between the chip (3.3V) and Arduino (5V?) operating voltage. I'll leave the rest to you.

i'm also working with tdc7200 i have interfaced clock correctly and also i started working it with msp430
the code i have used....i was getting output as 0 it isn't taking any inputs can anyone help me out to resolve the problem

i have attached the following code what i have used

code