Riva:
jvdl:
How would I do that?By the looks of the image from the sparkfun site you will need a soldering iron & solder to change the RX/TX pins. The jumper pads look like they are where I circled with a blue line.
Ok so that was obvious. Did'nt really knew it worked like that you only need to solder is to the left or right depending on which pin you want. So the jumpers are set correctly for pin 2 and 3 which is default I believe when I view the layout of the board.
So the module still is not working and I'm still nog satisfied on the power supply. Does any one know iff the board needs more than the 5v usb can give? I have read that the module needs 9v to operate correctly.