I thought that the following code would give me change in pin 8's state at about 125KHz. I think it's setting the overflow interrupt on Timer0. bool state = HIGH; void setup() { pinMode(8, OUTPUT); noInterrupts(); TCCR0A = 0; TCCR0B = 0; TCCR0B |= (1 << CS02); TIFR0 |= (1 << TOV0…

Even if you don't need millis() function, you can't use TIMER0_OVF_vect because the Arduino Core has defined a Timer0 overflow interrupt (a.k.a. TIMER0_OVF_vect). If you write multiple ISRs of the same vector, a compile error will occur. Try using TIMER0_COMPA_vect instead of TIMER0_OVF_vect. The…

TIMER1 Good, Timer0 Bad

Projects Programming

system Closed April 4, 2022, 5:47pm 10

This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.

Topic		Replies	Views
ISR(TIMER0_OVF_vect) gives a compiler error Programming	7	2622	May 5, 2021
Problem with ISR(TIMER0_OVF_vect) Syntax & Programs	7	20350	May 6, 2021
TIMER0_OVF_vect compile error Programming	7	11249	May 5, 2021
timer interupts Syntax & Programs	3	1844	May 6, 2021
timer 2 and millis() Syntax & Programs	9	6015	May 6, 2021

TIMER1 Good, Timer0 Bad

Related topics