Hello friends, I have a problem, please help me I have a tinybee v1 board, I use Marlin 2.1.2.5 firmware, everything works fine, but my only problem is that no matter how much z offset I give during printing, it has no effect, but it is applied in the next print, not on that print. Please if anyone can help me
Btt_mini_12864 v2
I moved your topic to an appropriate forum category @akhteh.
In the future, when creating a topic please take some time to pick the forum category that best suits the subject of your topic. There is an "About the _____ category" topic at the top of each category that explains its purpose.
This is an important part of responsible forum usage, as explained in the "How to get the best out of this forum" guide. The guide contains a lot of other useful information. Please read it.
Thanks in advance for your cooperation.
This topic was automatically closed 180 days after the last reply. New replies are no longer allowed.