I've run into a bit of trouble with my latest circuit. The signal it generates is flippin' awesome, but I cannot read it into the Arduino without ridiculous amounts of noise. I think it is related to the differences in ground voltage between the arduino and my circuit. running a wire from the output…

Too much noise when reading Amplified Analog Signals

Topic		Replies	Views
Op-amps General Electronics	41	11300	May 6, 2021
Adding DC offset to Amplified Signal using Arduino's 5V and GND General Electronics	3	2847	May 6, 2021
Can I connect my LM741 Op-Amp like this? Interfacing	26	20567	May 6, 2021
Reading output from Op Amp Sensors	20	7507	May 6, 2021
Strange problem with Op-amp General Electronics	4	1793	May 6, 2021