I am trying to use a sound sensor to activate a servo but I can't figure out what is wrong with my code I am using an Arduino Nano And this sound sensor Jocestyle High Sensitivity Sound Microphone Sensor Detection Module Fit for Arduino Here is my code: #include <Servo.h> int sensorAnalogPin …

Thanks for the diagram, a bit scruffy but much better than nothing. [image] nuthead411: if(digitalValue>300) A digital signal can be 0 or 1 it can never reach 300. You want to be looking at the analogue reading here not the digital one. You should not be trying to run a servo off the Arduin…

Tring to build a sound activated servo but code won't work

Other Hardware Sensors

nuthead411 October 17, 2021, 3:51am 14

so how would i go about fixing this

Topic		Replies	Views
servo activation via sound sensor Programming	4	1568	May 5, 2021
Servo disrupting analog values from sensor Programming	7	770	May 5, 2021
sound level to control a servo General Guidance	6	3970	May 5, 2021
Servo motor controled by audio Programming	3	4692	May 5, 2021
Help replicating Project on Arduino Programming	7	615	May 6, 2021

Tring to build a sound activated servo but code won't work

Related topics