I'm full of superises here, I was working on my sketch's when I came across this message.
avrdude: stk500_getsync(): not in sync: resp=0x00...
I changed usb ports, I still get the same message. I also looked at the board and the yellow led doesn't come on anymore. Is there a way to get it fixed.
Thanks
D
I'm full of superises
...but not much detail
Ok, I was working on a sketch about how to use serial commands on attiny85 once I was done I tried to upload the sketch onto a attiny85 chip and I got this message. I looked at the settings on the program to make sure the Board, com port and programmer is set right, which it was. All I got was yellow led flashing next to the letter L.
See reply #1
That all I could tell you, What more do you need?. the settings on the program or what type of board I have here?.
Yes... Difficult?
Doc
Ok, I have arduino uno R3 Make special edition that is set to com port 4 I am also using attiny85 for my project. the Programmer is set to arduino with isp, serial port set to port 4 and the board is set to attiny85 1mhz.
Is it possible to get it fixed or do I need to buy a new arduino board.
I have fixed the error problem, Now I am back in business again. Doesn't take a new person to find out..lol