Two NRF24L01 Transmitters sending temperatures to one Receiver

I have two devices transmitting temperature to one receiver. Right now only one at a time will work displaying the proper temperature. This verifies that the hardware on each transmitter is working and Serv1 & Serv2 are properly set up.

Mirf.getData((byte *) &temp1); //small board
//Mirf.getData((byte *) &temp2); //large board

when both lines are uncommented out I can see that one temperature is correct but the other reads a constant wrong temperature.

I’m no good at code as you can tell so any help would be great.

#include <MirfHardwareSpiDriver.h>
 
int16_t h = 64;
int16_t w = 128;
// OLED I2C bus address
#define OLED_address  0x3c
Adafruit_SSD1306 display(OLED_RESET);
float temp1;  //int
float temp2;
 
void setup()
{
  Serial.begin(9600);
  Wire.begin();
  Mirf.cePin = 8;
  Mirf.csnPin = 9;
  
  display.begin(SSD1306_SWITCHCAPVCC, 0x3c);  // initialize with the I2C addr 0x3D (for the 128x64)
  display.clearDisplay();   // clears the screen and buffer 
  Wire.begin();
  init_OLED();
  reset_display();           
 
  Mirf.spi = &MirfHardwareSpi;
  Mirf.init();
  Mirf.setRADDR((byte *)"serv1");   //has to be serv1 !
  Mirf.setRADDR((byte *)"serv2"); //has to be serv2 !
  Mirf.payload = sizeof(temp1); 
  Mirf.payload = sizeof(temp2);
  Mirf.config();
}
 
void loop()
{ 
  while(!Mirf.dataReady())
  {
  }
  
  //Can only use one at a time or gives an error one on Serv2
  Mirf.getData((byte *) &temp1);  //small board
  //Mirf.getData((byte *) &temp2);  //large board
 
  Serial.println(temp1);
  Serial.println(temp2);
 
  display.setTextSize(1);
  display.setTextColor(WHITE);
  display.setCursor(0,10);
  display.print("Small Brd:");
  
  display.setTextSize(1);  
  display.setTextColor(WHITE);
  display.setCursor(70,10);  //over,up
  display.print(temp1);  
  
  display.setTextSize(1);
  display.setTextColor(WHITE);
  display.setCursor(0,40);
  display.print("Large Brd:");
  
  display.setTextSize(1);  
  display.setTextColor(WHITE);
  display.setCursor(70,40);  //over,up
  display.print(temp2);